Viking 300 Highline – Tropicale

The Viking 300 is fully hand molded featuring a gel coat exterior strengthened by chopped strand matt.

All exterior fittings are in stainless steel and the boat has side decks of approximately 10" in width, sturdy handrails are located on the cabin top and the bow is surrounded by a stainless-steel pulpit.

The cockpit screens are four section fixed which are fold able for navigation beneath the lowest of bridges. 

The cabin side windows are of a one-piece section giving the maximum amount of light into the cabin.

Hull windows are fitted to the port side giving additional light to the cabin.

The transom is fitted with a molded bathing platform which features an outboard pod and integral steps to the side decks

The Viking 300 cockpit features the helm to port with steering via a cable to the outboard, single lever engine controls and ancillary switches.

A double helm seat with storage below is to port with further seating area aft in a U shape design giving space for a further six in comfort.

The central aft seating is removable, and this gives access to an opening transom door allowing easy boarding to the bathing platform and access ashore to port and starboard

The interior of the Viking 300 offers accommodation for six with a minimum headroom of over 6' The cabin is laid out in a airy open plan design with a large circular seating area forward a spacious dinette with hull window giving great natural light to port with the galley opposite to starboard. The toilet room is fitted with a cassette flush toilet, shower, glass surface mounted sink, and full vanity unit. Opposite this on this boat the option of a separated mid cabin with bulkhead and door features giving a private sleeping cabin aft with good access and beneath the cockpit floor a generous double berth being 7' in length with an opening window to the cockpit and a large hull window to the exterior. Aft again a large storage locker for tender or other useful items.

STANDARD INVENTORY

Stainless steel pulpit rail
Stainless steel hand rails to cabin top
Stainless steel hand rails below side screens
Three cleats
Six fender eyes
Two fairleads
Aluminium rubbing strake with plastic insert
Black Powder coated five section fixed windscreen
Black Powder coated cabin side windows of one piece section
Black Powder coated forward facing cabin window
Cabin ventilation fixed
Hull side decals Grey & Black
Molded bathing platform to transom with steps to side decks
Cable steering system and wheel
Three batteries
Rotary type battery master switch
12 v switch panel
Cockpit Light
Navigation lights
Interior cabin LED lighting
Water pump
Galley sink with hot and cold mixer tap
2 burner gas hob
Gas oven and grill
Gas test point
Gas fired hot water boiler
Cassette flush toilet Fresh water electric flush
Mixer shower unit
Vanity unit and basin in shower room
Shower drain pump
Interior joinery in Oak veneer ply paneling
Interior upholstery soft upholstery
Cream colored curtains
Hull lining soft linings
Saloon floor upgraded to wood veneer
Canopy in Black Cotton Canvas

300 Model further standard items

1 USB socket to dash
Gas Fired cabin heating, 240-volt battery charger
Simulated Teak cockpit floor
Low Level cockpit lighting
300 model hull decals
2 side windows to port side hull
300 model cabin window design in black anodized frames

Additional Options

Honda BF 50 Power tilt
Honda Rev counter Log & Depth gauge
Rudder safe
2 x 25 litre Honda fuel tank
Dragonfly-5 -PRO-SONOR GPS (Speed and depth log)
Victron Bluetooth Battery Charger
Bow thruster
Starboard side copilot seat with second fridge below
Flip back helm seat
Solid Water tank with Water gauge
Cockpit seating with base and back cushions in Silvertex covering with aft removable infill to transom door
Ring main, shore power and shoreline
Cockpit floor simulated teak
Wood floor / soft linings and upgraded upholstery to interior
Double USB to 240v sockets,
12v tv to aft bulkhead
Voltmeter, USB, 12v dash socket depth and log
Heating gas fired with 1 outlet in cabin
8 Fenders, 4 lines,

Whilst every care has been taken in their preparation, the correctness of these particulars is not guaranteed. The particulars are intended only as a guide and they do not constitute a term of any contract. A perspective buyer is strongly advised to check the particulars and where appropriate to have the vessel fully surveyed, inspected and sea or river trialled depending on location of the boat.

Tingdene Boat Sales have a high level of experienced staff to cater to a wide audience of clients, some with over 40 years in the marine industry. New Boat Builders for whom we offer boats from include:- CRANCHI YACHTS, BANKS MARTIN INLAND CRUISERS, DAYBOATS AND SLOOPS, VIKING RIVER CRUISERS & VIKING CANAL BOATS WIDEBEAM BARGES.

The Tingdene Boat Sales, Thames and Kennet Marina office is located in the heart of the action on the middle reaches of the River Thames.

Being home to all types of boats from open day boats & luxury cruisers to sports cruisers, narrow boats, wide beams & Dutch barges.

All berths are on floating pontoons off the main river, unaffected by river conditions allowing 24/7 access to your boat.

 Thames and Kennet Marina is the largest of the 9 Marinas owned by Tingdene Marinas & Boat sales Ltd with 450 berths for craft up to 100'.

A berth is guaranteed to all purchasers of craft from any Tingdene office.

On site is a 50 ton capacity Wise travel lift allowing craft to be launched and offered for marketing or delivered elsewhere following purchase.

 Selling our leading brands and offering an extensive after sales service to our clients, makes us the leading brokerage company in the area in both size and facilities.

Please contact Guy Girling, Nathan Kipling or Charlotte Swallow to discuss Buying, Selling or Berthing a boat at Tingdene Thames & Kennet Marina on [email protected] - +44 (0) 118 947 7770